![]() ![]() The sleeve is easily applied and removed, sliding on/off of the lense. I expect the performance to increase significantly. This is with the FLAT lense "Bad" camera mind you. My current settings are: Min Size: 2.5, Max Size 6.0, Brightness: 15/255, Gain: 12, and Exposure: 200. Even bright lights can be overcome with some tuning in opentrack. Credits The instructions were originally written original by weczi of IRTrack. The open driver should now become available in opentrack. Install the libusbK development kit original. As verses mais baixadas do programa so 5.3, 5.1 e 5.0. CL-Eye Driver foi originalmente criado por Code Laboratories, Inc. Uninstall any existing closed-source driver. Os arquivos do instalador do programa so conhecidos como CL-EyeTest.exe, CL-Eye Device Manager.exe, CL-Eye-Driver-5.exe ou Driver.exe. I clamped it (WITH A FILM OVER THE LENSE FOR PROTECTION!!!) while it set/dried and it worked like a charm. Instructions Open the Windows Device Manager. Alternatywny sterownik odbiornika podczerwieni - kamery PS3 Eye - darmowy. It filters out wavelengths under 1K nm I believe. Inside this lip I carefully set and superglued a 1" diameter Edmunds Optics plastic infared long pass filter that I got on eBay for $3. I cleaned the entire rubber piece with rubbing alcohol to remove dust and debris. Then I used a Dremel tool with a sanding bit to create a 1" lip. From the factory, this device has pretty impressive specs, but no windows drivers. I drilled/cut a 7/8 hole in the center for the lense (at this point you can look through it like a pipe). The NUI Group has been working hard to bring the PS3 Eye to windows. From the pop-up menu, select Update Driver. In the Device Manager, choose the PS3 EyeToy camera by performing a right-click. ![]() Download and unzip the PS3 EyeToy camera driver that corresponds to the mentioned model to your desktop (see Resources). The bottom, once flat, will be about 1-1/4" because it tapers. Take note if the PS3 EyeToy camera is described as a Namtai or Logitech model. I then cut off the convex bottom (the part that would go on the floor) and sanded it flat. I cut off ~ 1/4 inch from the length of the tube off the end in which you would place the leg of the chair. They sell them in a 4 pack for a few bucks. I went to Home Depot and bought a 7/8" (NOT the 1") rubber bottom for a chair. ![]() I tried using floppy disk film, clear plastic colored black, and stacking lenses but nothing worked better than this for blocking unwanted light and ease of use. I decided making a sleeve for my PS3 eye camera would be best. COMO USAR A PS3 PLAYSTATION EYE CAMERA NO PCCOMO USAR A PS3 EYE CAMERA NO PC - Cmera do Playstation 3Juntamente com a maior doao de lixo eletrnico. PS3 Camera IR Longpass Filter and Removable Rubber Sleeve ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |